As a NI partner Egypt, Omni Dynamics can technically support all institutions, users and researcher who use NI products.
National Instruments Products
Programing hardware products
Omni Logger
Labview based solution for measuring and logging data.
Small, simple and affordable, Omni Logger can measure
and record data at specified intervals. Omni Logger Software
requires no programming skills, and enables the user to
effortlessly select reading channel, specify the offset for data
calibration, and initiate the start of data collection.
Omni Logger works effectively with all National
Instruments data Acquisitions since the software is developed
using LabView Programing.
Omni Analyzer
LabView based solution for Analyzing Data
.png)
Small, simple and affordable, Data Analyzer can read
and analyze measured Data and export waveform graphs at
specified intervals of times for the needed channels. Data
Analyzer software requires no programming skills, and enables
the user to effortlessly read, analyze, and demonstrate the
recorded data.
Data Analyzer works effectively with all TDMS data file
recorded by Omni Logger Software.
OD Simulator
Labview based solution for Aircraft Simulation
Enviroment created to simulate the aircraft dynamics
OD ROV
Strategic Solution for Under water mission
Remotely Operated Vehicle for critical under water inspection
OD IEPE Signal Conditioner
Low Cost IEPE Signal Conditioners
OD IEPE signal conditioning units feature single and multi channel (up to 4 channels), with typical uses in modal analysis, condition/vibration monitoring, aerospace and automotive. [Download Data Sheet]
Omni Cloud
Omni Cloud Solution
OD Omni Cloud is a service presented by Omni Dynamics, which aims to give engineers new horizons in the measurements field. The operator can display, save, analyze and control his measurements remotely and can show his faraway colleagues simultaneously the data measured. Furthermore the data measured is uploaded on Omni Dynamics servers. [Download User Manual]
Omni Space
Embedded Solution for wireless Bridge Measurments
The Measuring System consisting of two main units:
1-
Measuring Unit:
A portable, light weight, wireless measuring unit can
acquire synchronized data using GPS timestamping and
synchronization module. The unit has various types of I/O
Modules for thermocouples, LVDT and AC/DC analog input. The unit
is adapted for hard environments, where it can operates at
high/cold temperatures, moreover, it send the data without using
wires through the integrated access point, furthermore, it
contains an independent source of power. All these features are
integrated in a case for better mobility than heavy measuring
units.
2-
Host
Host acquires, save, analyze and display data from the
measuring units. Host can be accessed from any place in the
world since it’s connected to the internet, so if you are apart
from the measuring field you can monitor the units through the
host. The unit is adapted for hard environments, moreover, it
send the data without using wires through the integrated access
point, furthermore, it contains an independent source of power.
All these features are integrated in a case for better mobility
than heavy PXI measuring units.
